TM 11-5821-333-30
6-31, TEST ADAPTER CONNECTORS. Continued
e. Replacement of Connector P4. Continued
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Place shield (3) on cable.
Solder wires to connector leads.
Remove wire tags.
Insert connector (4) into shield (3). The
groove on the shield (3) must be on the end
next to pin A.
Install jackscrews (7) from front of connec-
tor. The male jackscrew must be on the end
next to pin A.
Install spacer tubes (8) and washers (9) on
jackscrews (7).
Install jackscrew knobs (6) on jackscrews
(7). Removal of one or more of the washers
supplied with the connector may be neces-
sary to maintain snug fit between jackscrew
knobs (6) and spacer tubes (8).
Use needle nose pliers. Install pins (5) in
jackscrew knobs (6) and jackscrews (7).
Install and tighten four screws (2) securing
connector (4) to shield (3).
Tighten two screws on cable clamp (1).
6-201
