TM 11-5821-333-30
6-31. TEST ADAPTER CONNECTORS. Continued
b. Replacement of Connectors J1, J2, J6, J7, J20, and J21
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK-100/G
Tool Kit, Electronic Equipment, TK-105/G
Pin removal/installation tool included in connector packages
Equipment Conditions
Interconnecting device removed from chest (paragraph 6-22).
References
See paragraph 6-35 to remove and install shield panel when replacing J20 and J21 .
REMOVAL
NOTE
1.
2.
3.
4.
5.
Use screwdriver and nut driver. Loosen and
remove four screws (1), Iockwashers (2),
When replacing connector J6, remove three loop
clamps securing wires connected to J6.
and nuts (3) securing connector (4) to front
panel (5). Discard Iockwashers.
Pull connector out of front panel.
Tag wires.
Use pin removal/insertion tool to remove all
pins from connector.
Dispose of connector.
1.
2.
3.
Get new connector and Iockwashers.
4.
If any pins are damaged or missing, replace
them.
5.
Use pin removal/insertion tool to install all
pins in new connector, Check that pins are in
correct positions.
INSTALLATION
Insert connector in front panel. Orient to al-
low normal reading of pin designations on
front of connector,
Thread and tighten four screws (1) through
front panel (5), connector (4), Iockwashers
(2), and nuts (3).
6-197
