TM 11-5821-333-30
6-31. TEST ADAPTER CONNECTORS. Continued
e. Replacement of Connector P4
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Expendable Supplies
Tool Kit, Electronic Equipment, TK-100/G
Solder
Tool Kit, Electronic Equipment, TK-105/G
Equipment Conditions
Interconnecting device removed from chest (paragraph 6-22).
REMOVAL
1.
2.
3.
4.
5.
6.
7.
8.
Fully loosen two screws securing cable
clamp (1).
Remove four screws (2) securing shield (3)
to connector (4).
Use small jewelers screwdriver. Push out pin
(5) securing jackscrew knob (6) to each of
the two jackscrews (7).
Remove jackscrew knobs (6) by rotating
knobs counterclockwise.
Remove jackscrews (7), spacer tubes (8),
and washers (9).
Pull shield (3) away from connector (4) and
tag position of each wire.
Unsolder each wire from connector leads.
Remove connector.
6-200
