TM 11-5821-333-30
6-30. TEST ADAPTER WIRES
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Tool Kit, Electronic
Tool Kit. Electronic
Equipment, TK-100/G
Equipment, TK-105/G
Equipment Conditions
Interconnecting device removed from chest (paragraph
References
Removal and installation of soldered wire connections
Expendable Supplies
Wire
Tiedown Straps
Solder
6-22) .
(paragraph 6-29.g).
Removal and installation of terminal lug wire connections (paragraph 6-29.f).
Removal and installation of pins from circular multi-pin connectors (paragraph 6-31).
Removal and installation of wires from connectors P4, P5, and P10 (paragraph 6-31).
REMOVAL
1.
2.
3.
4.
5.
Find ends of wire to be replaced.
Disconnect ends of wire.
Use diagonal cutting pliers. Cut any tiedown
straps securing wire.
Use screwdriver and nut driver. Loosen and
remove all screws, Iockwashers, flat wash-
ers, loop clamps, and nuts securing wire.
Remove wire from test adapter.
INSTALLATION
1.
Route wire into place in the test adapter.
NOTE
2. Connect ends of wire to correct positions.
If wire is bundled in plastic spiral wrap, then use
the bad wire to pull the good wire into place when
3, Use screwdriver and nutdriver. Install all loop
removing the bad wire.
clamps, screws, nuts, Iockwashers, and flat
washers used to secure wire to test adapter.
4. Replace any tiedown straps cut to remove
wire.
6-195
