TM 11-5821-333-30
6-27. TEST CABLES
This task covers repair of cables W1, W2, W3, W7, W8, and W17.
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK-105/G
Pin removal/installation tool included in connector packages
1.
2.
3.
4.
5.
6.
7.
Remove two screws, their washers, and the
brackets from the cable clamp adapter.
The connector’s outer collar has three holes
through it. Aline one of these holes with a
notch in the flange under the collar. Place a
small jeweler’s screwdriver through the collar
hole and into the notch. Unscrew the cable
clamp adapter from the connector.
Using a pin insert/extract tool supplied with
the connector, remove all the pin from the
connector. Mark each pin by its location on
the connector. If insulating sleeving or sleeve
markers are damaged, replace as needed.
Discard connector, and obtain a new or
known good one.
Using a pin insert/extract tool supplied with
the connector, install the pins according to
their marked locations. Check to make sure
all pins are fully seated.
Hand tighten the cable clamp adapter onto
connector. Aline one of the holes in the collar
with a notch in the flange under the collar,
Place a small jeweler’s screwdriver through
the collar hole and into the notch. Tighten the
cable clamp adapter the rest of the way.
Position rubber grommet into place. Install
and tighten the two screws, their washers,
and the two brackets.
6-189
