TM 11-5821-333-30
5-9. MT-6373 MOUNTING BASE. Continued
DISASSEMBLY
1. REMOVE lNJECT/EJECT LEVER.
a. Remove two screws (1), two Iockwashers (2), two washers (3), and two shoulder washers (4), securing
lever (5) to structural section (17).
b. Remove four screws (14), four Iockwashers (15), and four washers (16) securing structural section
(17) and shim (17A) to tray (6).
c. Save all shim material (17A) for reinstallation.
2. REMOVE LATCH.
a. Remove four screws (10), four washers (11), four Iockwashers (12), and four nuts (13) securing guide
(9) to tray (6).
b. Lift handle latch (7) and spring (8) from guide (9).
3. REMOVE IDENTIFICATION PLATE.
a. With pocket knife, peel off identification plate (18).
b. With cotton swab and alcohol, clean adhesive from structural section (17).
4. REMOVE CABLE (W1).
a. Remove screw (18), washer (19), Iockwasher (20), and nut (21) securing clamp (22) to tray (6). Re-
move clamp (22).
b. Remove two screws (23), two washers (24), two Iockwashers (25), and two nuts (26) securing W1J1 (27)
to back of tray (6).
c. Remove cable by pulling W1J1 (27) and W1P6 (36) through hole in tray (6).
5. REMOVE RF CABLE (W2, W3, or W4).
a. Remove screw (18), washer (19), Iockwasher (20), and nut (21) securing clamp (22) to tray (6),
b. Remove two pins (32), two Iockwashers (33), and two washers (34) securing connector retainer (31) to
tray (6).
c. Remove assembly consisting of cables (28, 29, and 30) and connector retainer (31)
d. Grip cable (28, 29, or 30) near where connector is seated in connector retainer (31) Use pliers to com-
press spring (37), and pull cable free.
6. REMOVE GROMMET.
Compress grommet (35) and remove from tray (6).
7. REMOVE BOLT ASSEMBLY.
a. Using a needle nose pliers, remove cotter pin (38) from straight pin (39).
b. Remove straight pin (39) and bolt assembly (40) from tray (6).
ASSEMBLY
1. INSTALL LATCH.
a. Place spring (8) on guide (9).
b. Place handle latch (7) on guide (9).
c. Attach guide (9) using four screws (10), four washers (11), four Iockwashers (12), and four nuts (13).
5-4
