TM 11-5821-333-30
5-9. MT-6373 MOUNTING BASE. Continued
2. INSTALL lNJECT/EJECT LEVER.
a.
b.
Attach structural section (17) and shim (17A) using four screws (14), four Iockwashers (15), and four
washers (16). Select shim (17A) material to maintain dimension shown in following figure.
Install two screws (1), two Iockwashers (2), two washers (3), and two shoulder washers (4) to secure
l e v e r ( 5 ) t o s t r u c t u r a l s e c t i o n ( 1 7 ) .
3. INSTALL IDENTIFICATION PLATE.
a. Peel backing from new identification plate (18).
b. Press into place on structural section (17).
4. INSTALL CABLE (W1).
a.
b.
c.
d.
Feed W1J1 (27) and W1P6 (36) through hole in tray (6).
Attach W1J1 (27) to tray (6) using two screws (23), two washers (24), two Iockwashers (25), and two nuts
(26). Connector mounting flange must be on outside of tray. Narrow side of shell around pins must be to
top of tray.
Place clamp (22) around cables W1 through W4 as shown on sheet 2 of figure 5-2.
Attach clamp (22) to tray (6) using screw (18), washer (19), Iockwasher (20), and nut (21).
5. INSTALL RF CABLE (W2, W3, or W4).
a.
b.
c.
d.
e.
Position connector retainer (31) so countersunk side is away from cable, and press cable into connector
retainer (31).
Attach assembly consisting of cables (28, 29, and 30) and connector retainer (31) to tray (6) using two
pins (32), two Iockwashers (33), and two washers (34).
CAUTION
Be sure to position connector retainer (31) so that W2 is marked COM, W3 is marked RT, and W4
is marked LT.
Feed cables through clamp (22) as shown on sheet 2 of figure 5-2.
Install screw (18), washer (19), Iockwasher (20), and nut (21) to secure clamp (22) to tray (6).
Feed cables (28, 29, and 30) through hole in tray (6).
6. INSTALL GROMMET.
a. Trim grommet (35) to size.
b. Compress grommet (35) and install in tray (6).
7. INSTALL BOLT ASSEMBLY.
a. Position bolt assembly (40) into hinge on tray (6).
b. Install straight pin (39) through hinge and bolt assembly (40).
c. Using needle nose pliers, install cotter pin (38) through straight pin (39).
5-5
