TM 11-5821-333-30
5-10. MT-6373 SYSTEM CABLE (W1)
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK-105/G
Insertion/Removal Tool
Crimping Tool
References
Figure 5-3 shows parts location.
DISASSEMBLY
1. REMOVE CONNECTOR - J1 or P6.
Use removal tool to remove contacts from connector (1 or 2). Tag wires for reassembly.
2. REMOVE CONNECTOR - P1 or P2.
a. Loosen two screws that secure backshell (3) to cable.
b. Unscrew backshell (3) from connector (4).
c. Use removal tool to remove contacts from connector (4).
ASSEMBLY
1. INSTALL CONNECTOR - J1 or P6.
a. If any contacts are damaged, remove using diagonal cutters. Install new contact using crimping tool.
b. Use insertion tool to insert contacts into connector (1 or 2).
2. INSTALL CONNECTOR - P1 or P2.
a. If any contacts are damaged, remove using diagonal cutters. Install new contact using crimping tool,
b. Use insertion tool to install contacts in connector (4).
c. Screw backshell (3) onto connector (4).
d. Tighten two screws on backshell (3).
5-9
