TM 11-5821-333-30
6-38. TEST ADAPTER RF SECTION COMPONENTS
This paragraph gives the replacement procedure for all attenuators, rf dividers, and adapters used in the test
adapter rf section.
This task covers: a. Removal
b. Installation
Tools
Tool Kit, Electronic Equipment TK-100/G
Tool Kit, Electronic Equipment TK-105/G
Equipment Conditions
Test adapter removed from interconnecting device (paragraph 6-28).
References
See paragraph 6-29 for removal and installation of rf cables.
See figure 6-43 for location of rf section components.
1.
2.
3.
Loosen and remove any loop clamps secur-
ing bad component.
Disconnect any rf cables or other rf section
components from bad component.
Remove bad component.
1.
2.
3.
Place good component in position.
Connect any rf cables or other rf section
components that were disconnected.
Install any loop clamps used to secure the re-
placed component.
6-212
