TM 11-5821-333-30
5-11. MT-6374 MOUNTING BASE
This task covers:
a. Disassembly
b. Assembly
INITIAL SETUP
Tools
Expendable Supplies
Tool Kit, Electronic Equipment, TK-105/G
Cotton Swab and Alcohol
References
Figure 5-4 shows parts location.
DISASSEMBLY
1. REMOVE BOLT ASSEMBLY.
a. Using a needle nose pliers, remove cotter pin (1) from straight pin (2).
b. Remove straight pin (2) and bolt assembly (3) from tray (4).
2. REMOVE IDENTIFICATION PLATE.
a. With pocket knife, peel off identification plate (5).
b. With cotton swab and alcohol, clean adhesive from tray (4).
ASSEMBLY
1. INSTALL BOLT ASSEMBLY.
a. Position bolt assembly (3) into hinge on tray (4).
b. Install straight pin (2) through hinge and bolt assembly (3).
c. Using needle nose pliers, install cotter pin (1) through straight pin (2).
2. INSTALL IDENTIFICATION PLATE.
a. Peel backing from new identification plate (5).
b. Press into place on tray (4).
Section V. PREPARATION FOR STORAGE OR SHIPMENT
5-12. GENERAL INFORMATION
Pack the mounting base in an approved shipping container.
5-11
