TM 11-6110-211-15
4-3. Test Requirements for AM-3209/ASN
to middle position, and S-103 VOLTAGE
Using the AM-3209/ASN Test Panel
TEST to 7.
a.
Test.
(2) Connect
AM-3209/ASN to test
panel.
(1) Set test panel switches as follows:
S-101 ON-OFF to OFF, S-102 IN 0-OUT 0
( 3 ) Measure resistance according to
the following chart using TS-352B/U.
Corresponding pin
6K to 9K
J103
J106
3
and 6
J104
8K to 12K
4
and 6
J106
J101
6K to 9K
1
and 6
J106
1K to 3K
J105
J106
5
and 6
35 to 70
J107
J112
7
and 12
2 to 12
J108
J112
8
and 12
B. Zero Signal Voltage Test.
terclockwise.
(1) Set S-102 IN O-OUT
to IN O.
(3) Set S-101 ON-OFF to ON.
( 2 ) Rotate T-101 VOLTAGE ADJUST
(4) Rotate S-103 VOLTAGE TEST and
and R-101 POWERSTAT controls fully coun-
observe ac voltmeter M-101. Voltage read-
ings shall conform to the following chart.
S-103
VOLTAGE TEST
M-101 (volts ac)
Measurement
switch position
1
113 to 117
L i n e voltage . . . . . .
19 to 31
Generator excitation . . . .
2
3
19 to 31
Motor fixed field . . . . . .
0 to 0.9
Motor control field . . . .
4
0 to 0.9
Motor control field . . . . .
5
indicator and AN/USM-223 shall indicate
c.
In-Phase Torque Test.
(1) Connect ME-30B/U No. 1 to J-120
as shown*
using a PL-55 phone plug (ground side to
CAUTION
sleeve).
D o n o t a p p l y voltage too fast or
( 2 ) Connect AN/USM-223 between J-
d a m a g e to torque indicator may re-
113 and J-114.
sult.
(3) Connect ME-30B/U No. 2 between
J - 1 0 5 and J-106 (ground side to J-106).
(4) Set S-102 IN 0-OUT 0 to IN 0.
(5) Rotate AN/USM-223 FUNCTION
selector to TOTAL.
(6) Adjust input voltage as shown in
the following chart with R-101 POWERSTAT
a n d T-101 VOLTAGE ADJUST. Torque
4-4 Change 1
