TEST ADAPTER FRONT PANEL

TEST ADAPTER TERMINAL BOARDS TB1 AND TB2

TM-11-5821-333-30 Singcars Aiorborne Combat Net Radio ICOM and Non-ICOM AN/ARC-201 (V) Manual
Page Navigation
549

TM 11-5821-333-30 6-43. TEST ADAPTER FRONT PANEL This task covers: a. Removal b. Installation INITIAL SETUP Tools Tool Kit, Electronic Equipment, TK-100/G Tool Kit, Electronic Equipment, TK-105/G Equipment Conditions Test adapter removed (paragraph 6-28). References See paragraph 6-29 for removal and installation of rf cables. See paragraph 6-31 for removal and installation of connectors. See paragraph 6-32 for removal and installation of switches. See paragraph 6-33 for removal and installation of test points. See paragraph 6-34 for removal and installation of lamp holders. See paragraph 6-35 for removal and installation of shield panel and circuit breakers. REMOVAL 1. Set switches S1 through S6 to OFF. Set S15 to ICS. 2. Remove shield panel. 3. Disconnect from front panel– switches: S1 through S16 circuit breakers: CB1 and CB2 connectors: J1 through J21 4. Remove— lamp holders: test lamps 1 through 10, AC, and DC test points: 1 through 24 6. Remove five loop clamps secured to front panel. 7. Loosen and remove three nuts securing ter- minal lugs to front panel. One is next to S15, and two are next to S7. 8. Loosen and remove nuts and flat washers se- curing panel brackets to front panel. 5. Remove handles. 6-220

Privacy Statement
Press Release
Contact