TM 11-5821-333-30
2-38. IDENTIFICATION PLATE (RT-1477, RT-1477A, RT-1478, AND RT-1478A)
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Expendable Supplies
Tool Kit, Electronic Equipment, TK-105/G
Cotton Swab and Alcohol
REMOVAL
INSTALLATION
1. With a pocket knife, peel off identification
1.
plate (1).
2.
2. With cotton swab and alcohol, clean adhesive
from rt.
Peel backing from new identification plate.
Press into place on rt.
Section V. PREPARATION FOR STORAGE OR SHIPMENT
2-39. GENERAL INFORMATION
a. Pack the rt and modules in approved shipping containers.
b. All modules must be shipped enclosed in material that provides protection from static electricity. See the
following paragraph.
2-40. PACKING STATIC SENSITIVE MODULES
The following steps should be followed when packing a static sensitive module for storage or shipment.
CAUTION
To avoid damaging static sensitive modules, use an antistatic pad on the work surface and wear
a grounded wrist strap when handling the module.
ITEM
ACTION
a.
b.
c.
d.
Module (1)
Antistatic package (4)
Antistatic package (4)
Shipping container (6)
a. Place inside antistatic bag (2) or inside antistatic
wrapping material (3). See figure 2–14.
b.
c.
d.
Seal with adhesive tape. Attach “sensitive elec-
tronic device” unit pack label (5).
Place inside approved shipping container (6).
Attach “sensitive electronic device” intermedi-
ate pack label (7).
2-169
