TM 11-5821-333-30
3-18. CONTROL PANEL (A1). Continued
3. REMOVE DISPLAY AND DISPLAY GASKET.
NOTE
It is not necessary to remove control panel.
a. Disconnect W1P3 (7) from back of display (16).
b. Remove two screws (15) that secure display (16) and display gasket (17) to front panel (10).
4, INSTALL DISPLAY AND DISPLAY GASKET.
a. Position display (16) and display gasket (17) on front panel.
b. Install and tighten two screws (15).
c. Connect W1P3 (7) to back of display (16).
5. REMOVE LIGHTED PANEL/KEYBOARD AND GASKET,
a. Disconnect W1P1 (6) from back of front panel (10).
b. Remove six screws (9) securing lighted panel/keyboard (11) and gasket (12) to front panel (10).
6. INSTALL LIGHTED PANEL/KEYBOARD AND GASKET.
a.
b.
3-190
Secure lighted panel/keyboard (11) and gasket (12) to front panel (10) using six screws (9). Use
sealing compound on six screws.
Connect W1P1 (6) to back of front panel (10).
CHASSIS (A5)
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK-105/G
REMOVAL
1. Remove access cover (para 3-15).
2. Remove bus interface module and processor module (para 3-16).
3. Remove power supply (para 3-17).
4. Remove control panel (para 3-18).
INSTALLATION
1. Install control panel (para 3-18).
2. Install power supply (para 3-17).
3. Install bus interface module and processor module (para 3-16).
4. Install access cover (para 3-15).
3-72
