TM 11-5821-333-30
3-16. BUS INTERFACE MODULE (A2) OR PROCESSOR MODULE (A3)
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
Tool Kit, Electronic Equipment, TK–105/G
REMOVAL
1. Remove access cover (para 3-15).
2. Lift two card ejectors on bus interface module
(1) or processor module (2). If modules have
no card ejectors, use a module extractor to
remove modules.
3. Pull module free of chassis (3).
INSTALLATION
1.
2.
3.
4,
5.
6
Lift up card ejectors , if present, on bus inter–
face module (1) or processor module (2).
CAUTION
Be careful not to damage or bend
connector pins.
Insert module into card guides.
Press down on module. If present, card ejec-
tors should touch top of chassis (3).
Check alignment of connector. If present,
push down card ejectors.
Push down firmly on module until fully
seated.
Install access cover (para 3-15).
3-68
