TM 11-5821-333-30
2-24. TROUBLESHOOTING FLOWCHARTS. Continued
1. SET TEST ADAPTER:
DC
OFF
2. REMOVE POWER SUPPLY
(A10) FROM UUT.
3. REMOVE FRONT PANEL
(Al) FROM UUT.
4. REMOVE AMPL-OSC (A9)
FROM UUT.
5. USE DMM AND TEST
LEADS TO CHECK RESIS-
TANCE BETWEEN XA1-19
AND J1-41.
CHART 47
Take Control Test Failure
NOTE
See figure FO-10 for
location of test points.
1. DISCONNECT CABLE
FROM UUT ANCILLARY
CONNECTOR J2.
2. MEASURE RESISTANCE
BETWEEN J2-K AND
W1P1-41.
CHASSIS (A11) IS BAD.
FRONT PANEL (A1) IS BAD.
AMPL-OSC (A9) IS BAD.
2-155
