TM 11-5820-922-40-1
3. Align connector J1 (18) with
circuit board connector P1 (20), and
ASSEMBLY A1A3 REPLACEMENT (Figure 4-4,
Sheet 3).
carefully push into place and tighten
2 slotted thumb screws (17).
4. Align wire rope screw assembly (9)
1. Align J7 (16) with appropriate
hole in rear cover (6).
with the mounting stud (15), attach and
tighten.
5. Align cover (6) with amplifier-
2. Push J7 (16) into position and
converter housing, fit in place, and
attach lockwasher (2) and retaining nut
tighten 6 captive screws (28).
(1) and tighten.
