TM 11-5895-1090-24P
SECTION I
INTRODUCTION
Code
Definition
1. Scope
PA Item procured and stocked for anticipated or
This manual lists spares and repair parts; special tools;
special test, measurement, and diagnostic equipment
known usage.
(TMDE), and other special support equipment required
for performance of organizational, direct support, and
purpose because essentiality dictates that a
general support maintenance of the AM-6704/TSC. It
minimum quantity be available in the supply
authorizes the requisitioning and issue of spares and
system.
repair parts as indicated by the source and maintenance
PD Support item, excluding support equipment,
codes.
procured for initial issue or outfitting and stocked
2. General
only for subsequent or additional initial issues or
This Repair Parts and Special Tools List is divided into
Not subject to automatic
the following sections: a. Section II. Repair Parts List.
replenishment.
A list of spares and repair parts authorized for use in the
MD Item to be manufactured or fabricated at the
performance of maintenance. The list also includes
depot maintenance level.
parts which must be removed for replacement of the
XA Item is not procured or stocked because the
authorized parts. Parts lists are composed of functional
requirements for the item will result in the
groups in numeric sequence, with the parts in each
replacement of the next higher assembly.
group listed in figure and item number sequence.
XB Item is not procured or stocked. If not available
b. Section III. Special Tools List. Not applicable.
through salvage, requisition.
c. Section IV. National Stock Number and Part Number
XD A support item that is not stocked. When
Index. A list, in National item identification number
required, item will be procured through normal
(NIIN) sequence, of all National stock numbers (NSN)
supply channels.
appearing in the listings, followed by a list, in alphameric
NOTE
sequence, of all part numbers appearing in the listings.
Cannibalization or salvage may be
National stock numbers and part numbers are cross-
used as a source of supply for any
referenced to each illustration figure and item number
items source coded above except
appearance.
those coded XA and aircraft support
3. Explanation of Columns
items as restricted by AR 700-42.
a. Illustration. This column is divided as follows:
(2) Maintenance code. Maintenance codes
(1) Figure number.
Indicates the figure
are assigned to indicate the levels of maintenance
number of the illustration on which the item is shown.
authorized to USE and REPAIR support items. The
(2) Item number. The number used to identify
maintenance codes are entered in the third and fourth
item called out in the illustration.
positions of the Uniform SMR Code format as follows:
b. Source, Maintenance, and Recoverability (SMR)
(a) The maintenance code entered in
Codes.
the third position will indicate the lowest maintenance
(1) Source code. Source codes indicate the
level authorized to remove, replace, and use the support
manner of acquiring support items for maintenance,
item. The maintenance code entered in the third position
repair, or overhaul of end items. Source codes are
will indicate one of the following levels of maintenance:
entered in the first and second positions of the Uniform
Code
Application/Explanation
SMR Code format as follows:
O- item is removed, replaced, used at the
organizational level.
F- item is removed, replaced, used at the direct
support level.
1
