TM11-5820-287-34P-8
SECTION I
INTRODUCTION
Code
Definition
1. Scope
This manual lists spares and repair parts; special tools;
PA-Item procured and stocked for anticipated or known
special test, measurement, and diagnostic equipment
usage.
(TMDE), and other special support equipment required
XD-A support item that is not stocked. When required,
for performance of direct support and general support
item will be procured through normal supply
maintenance of the OA-1394/GRC. It authorizes the
channels
requisitioning and issue of spares and repair parts as
indicated by the source and maintenance codes.
NOTE
Cannibalization or salvage may be used as a
2. General
source of supply for any items source coded
This Repair Parts and Special Tools List is divided into
above except those coded XA and aircraft
the following sections:
support items as restricted by AR 700-42.
repair parts authorized for use in the performance of
(2) Maintenance code. Maintenance codes are
maintenance. The list also includes parts which must be
assigned to indicate the levels of maintenance
removed for replacement of the authorized parts. Parts
authorized to USE and REPAIR support items. The
lists are composed of functional groups in numeric
maintenance codes are entered in the third and fourth
sequence, with the parts in each group listed in figure
positions of the Uniform SMR Code format as follows:
and item number sequence.
(a) The maintenance code entered in the third
b. Section III. Special Tools List. Not applicable.
position will indicate the lowest maintenance level
authorized to remove, replace, and use the support item.
c. Section IV. National Stock Number and Part
The maintenance code entered in the third position will
Number Index. A list, in National item identification
indicate one of the following levels of maintenance:
number (NIIN) sequence, of all National stock numbers
(NSN) appearing in the listings, followed by a list, in
Code
Application/Explanation
alphameric sequence, of all part numbers appearing in
O-Support item is removed, replaced, used at the
the listings. National stock numbers and part numbers
are cross-referenced to each illustration figure and item
F-Support item is removed, replaced, used at the direct
number appearance.
support level.
3. Explanation of Columns
H-Support item is removed, replaced, used at the general
a Illustration. This column is divided as follows:
support level.
(1) Figure number. Indicates the figure number of
D-Support items that are removed, replaced, used at
the illustration on which the item is shown.
depot, mobile depot, specialized repair activity
(2) Item number. The number used to identify item
only.
called out in the illustration.
(b) The maintenance code entered in the fourth
b. Source, Maintenance ,and Recoverability (SMR)
position indicates whether the item is to be repaired and
Codes.
identifies the lowest maintenance level with the
(1) Source code. Source codes indicate the manner
capability to perform complete repair (i.e., all authorized
of acquiring support items for maintenance, repair, or
maintenance functions). This position will contain one
overhaul of end items. Source codes are entered in the
of the following maintenance codes:
first and second positions of the Uniform SMR Code
format as follows:
1
