TM 11-5895-1090-34/TO 31 R2-2TSC-152
WARNING
(9) Use a small paint brush or the tip of a pipe
cleaner dipped in trichlorotrifluoroethane. Thoroughly
Adequate ventilation should be provided
clean all newly soldered points. Be sure that all flux and
while using TRICHLOROTRIFLUORO-
resin are removed. A round toothpick may be used to
ETHANE. Prolonged breathing of vapor
remove heavy resin deposits. Solder points should be
should be avoided. The solvent should
clean, smooth, and bright.
not be used near heat or open flame;
(10) Use a small paint brush dipped in urethane
the products of decomposition are toxic
coating (M4605-8 type UR or equivalent) and cover all
and irritating. Since TRICHLOROTRI-
new solder points on both sides of the board.
FLUOROETHANE dissolves natural
oils, prolonged contact with skin should
be avoided.
When necessary, use
gloves which the solvent cannot
penetrate.
If the solvent is taken
internally,
consult
a
physician
immediately.
4-21